Hyperbolic aluminum veneer curtain wall, the overall shape of which is petal shape, is made of 2.5-thick aluminum veneer. The plate is a large and small head. After disassembly, the effect is not very good. The whole wall is uneven, and the reflective surface has obvious creases. There is always a feeling of imbalance. Today, I will help you analyze the reasons and how to do a similar project.

1. Possible installation problems, including installation system adjustment and site installation quality.

2. The first aluminum plate is too thin or the reinforcing ribs are unreasonably arranged, resulting in insufficient structural performance and environmental friendly performance of the aluminum plate itself.

Inadequate second support system, adjustment of horizontal and vertical frames, and error of main structures

The third problem in the construction process is a variety of problems.

The third and fourth problems are closely related to the company.

The problem of the fifth part connection usually exists in this link.

I have made many double curved buildings, such as stainless steel plate, double curved aluminum veneer, metal roof glass, etc. From my point of view, your effect has been very good.

3. One is the rational division, and the other is the production level of the aluminum plate deep processing unit.

4. Process problems: the deformation of the stressed part is too obvious, and the aluminum plate is very thin.

If you want to do well, you can only splice modules. Each plate is a separate and non interchangeable molded surface. After the sheet is formed, it is fixed with a uniform and interchangeable rear bracket. The size of the rear bracket is fixed, and the wall keel is matched. It is packed well during transportation and is not deformed. During installation, the support shall not contact the front molding surface, and the plastic surface shall not be affected. No deformation. It is better to stick it on the front film.

The whole installation is completed, and the packaging is from top to bottom.

I'm not making aluminum finishes, but I think if I do, there will be no problem. Wall mounting can cause distortion. You are fixed on the bracket in front of the wall, and the deformation range. It can be controlled to the minimum. After all, it is more accurate in the factory than on the site.

Of course, this will increase the cost of installation, rear support module, transportation and packaging. But a penny is worth it. It's not that it's bad, nor is it that the money is spent.

6. Possible installation problems, including system precautions for installation adjustment, on-site installation quality,

It may be an installation problem, precautions for system installation and adjustment, and on-site installation quality control.

7. It is a flat plate, and one of the reasons is estimated to be the uneven bending of the flat plate.

8. There are reasons for this. This kind of hyperboloid of manual installation operation, the effect of assembling one board and one board is inevitable. After all, drawing on a computer is not good.

First of all, the two songs you mentioned are just a hyperbola.

But in fact, the aluminum plate you use is a flat plate, so your aluminum plate is not hyperbolic, that is, the flat plate is assembled into a double curve shape.

This effect can be thought of by yourself. If the radius of the hyperbola is large enough, the arc length and chord length of a single plate are the same (that is, they are basically close), so the assembly effect will be better.. Otherwise, it is preferable to use hyperbolic treatment for individual plates.

Then, when processing hyperbolic aluminum veneer, the arrangement of reinforcing ribs, the deformation control of processing, especially the edge position. And then the color and difference of the aluminum surface layer are controlled.